Ethereum: How to resynchronize all blocks using `bitcoin-cli`?

Here is an article based on your request:

How to re-sync all blocks using Bitcoin-Cli

Occasionally, the Bitcoin Core (BTCP) client needs to be rebuilt the blocks in the Ethereum blockchain, but you are not sure where to start. Fortunately, there is a simple command that can help you achieve this: -Rescan.

In this article, we examine how to use Bitcoin-Cli 'to re-synchronize all blocks in the BTCP node.

How to re-sync all blocks usingBitcoin-Cli

To use-Rescan, you need to install the BTCP client and configure your machine. This is how you can do:

• Be sure to connect to the BTCP node by running "Bitcoin-Cli List" orBitcoin-Cli Getinfo”. If you are not sure, check the BTCP documentation for more information.

• After connection, run the following command:

`Bash

Bitcoin-Cli-Red

`

This begins the re -synchronization process, which takes time depending on the size of the blockchain.

Tips and variations

• If you want to synchronize a specific block range, use the “-START” and “-SSTOP” options. For example: Bitcoin -Cli Rescan -Sstart 1000 -Stop 20000"

Re-synchronization of all blocks in the BTCP node is a relatively simple process that uses theBitcoin-Clicommand line device. By following these steps and tips, you should be able to easily achieve this goal. Remember to keep a regular backup of the BTCP node to prevent data loss in the event of an emergency.

Note: This article assumes that you have basic knowledge of Bitcoin Core and its customer organs. If you are not already aware of the BTCP or theBitcoin-Cli` command line device, check out the official documentation for more information.

solana anchor fail